Mechanical structures for electrical and electronic equipment - Outdoor enclosures - Part 1: Design guidelines (IEC 61969-1:2020)
This part of IEC 61969 contains design guidelines for outdoor enclosures and is applicable over
a wide field of mechanical, electromechanical and electronic equipment and its installation
where a modular design is used.
The objectives of this document are:
– to provide an overview of specifications for enclosures focused on requirements for outdoor
applications for stationary use at non-weather protected locations, and
– to achieve product integrity under outdoor conditions and to ease product selection for the
sourcing of outdoor enclosures from different vendors.
These enclosures are considered to contain any equipment and provide protection for the
outdoor installed facilities against unwanted environmental impacts. The installed equipment
can be, but is not limited to, subracks or chassis according to IEC 60917 (all parts) or
IEC 60297 (all parts). A typical outdoor enclosure is shown in Figure 1.
ΚΩΔΙΚΟΣ ΠΡΟΪΟΝΤΟΣ:
CYS EN IEC 61969-1:2020
This part of IEC 61969 contains design guidelines for outdoor enclosures and is applicable over
a wide field of mechanical, electromechanical and electronic equipment and its installation
where a modular design is used.
The objectives of this document are:
– to provide an overview of specifications for enclosures focused on requirements for outdoor
applications for stationary use at non-weather protected locations, and
– to achieve product integrity under outdoor conditions and to ease product selection for the
sourcing of outdoor enclosures from different vendors.
These enclosures are considered to contain any equipment and provide protection for the
outdoor installed facilities against unwanted environmental impacts. The installed equipment
can be, but is not limited to, subracks or chassis according to IEC 60917 (all parts) or
IEC 60297 (all parts). A typical outdoor enclosure is shown in Figure 1.
