Protective gloves - General requirements and test methods (ISO 21420:2020)
This document specifies the general requirements and relevant test procedures for glove design and construction, innocuousness, comfort and efficiency, as well as the marking and information supplied by the manufacturer applicable to all protective gloves.
It can also apply to arm protectors and gloves permanently incorporated in containment enclosures.
Gloves and hand protectors such as mittens, pot holders and arm protection are covered by this document.
This document does not address the protective properties of gloves and therefore is not used alone but only in combination with the appropriate specific standard(s). A non-exhaustive list of these standards is given in the Bibliography.
ΚΩΔΙΚΟΣ ΠΡΟΪΟΝΤΟΣ:
CYS EN ISO 21420:2020
This document specifies the general requirements and relevant test procedures for glove design and construction, innocuousness, comfort and efficiency, as well as the marking and information supplied by the manufacturer applicable to all protective gloves.
It can also apply to arm protectors and gloves permanently incorporated in containment enclosures.
Gloves and hand protectors such as mittens, pot holders and arm protection are covered by this document.
This document does not address the protective properties of gloves and therefore is not used alone but only in combination with the appropriate specific standard(s). A non-exhaustive list of these standards is given in the Bibliography.